One Room Challenge | Week 5

Garage Edition

So, I’m still over here playing catch up. Welcome to week 5 of the ORC (Tomorrow starts week 7😬). Sorry guys, we’ve had lots of family stuff going on and family always comes first in my household. Let’s just dive right in, shall we?

This week was all about the gym side of the garage, and to be honest, I didn’t accomplish all that much this week. But you know what? Progress is progress! I’m taking my time with this so I don’t burn out and never finish.

PRX Performance Rack

One thing that I am super excited about, is our recent squat rack upgrade to the PRX Performance rack. It was a little bit more complicated to install than I anticipated, only because I was limited on where I could (or wanted to) mount it. The support beams have to be precise, otherwise it won’t fold up correctly, or at all. As you can see, we added stringer boards so that the rack could fold up without hitting the garage door opener or the window sill.

Stringer Boards

These stringer boards are 2 x 8, typically stringer boards are 2 x 10, but that wasn’t necessary with this application. With stringer boards, you want to have two bolts or lag screws per stud. In this case, we were installing this over four studs, so we have 8 3.5″ Lag screws per board (I did talk about electrical safety when using anything longer than 2″ screws on my previous post). I did use a spade bit to create the depth I needed for these lag screws to sit flush within the stringer board, so that I could install the PRX support beam over the board.

Support Beam

Once the stringer boards were installed, I used another four 3.5″ Lag screws to attach the support beam to the stringer board and stud. This thing isn’t going anywhere. The support beams can’t be more than 1/4″ off, otherwise this won’t work properly. My anxiety was high with this install, I am by no means a perfectionist when it comes to DIYing, and this required me to be. Now that the support beams are up, we used a plumb bob to ensure that they were perfectly aligned and finished tightening all of the Lag screws down.

Josh took over from here with the PRX installation while I went over and worked on installing the TV wall mount bracket and shelves. I used a 1 x 2 for my support and screwed that into the studs. Then just used what I had left over from my butcher block counters to make some shelves under neath the TV.

Building some shelves with the left over butcher block I had from the counter install
Josh finishing up the Squat Rack and I’m starting the TV wall bracket.

I want you all to just appreciate how close that rack was to the garage door bracket… Look below

There was less than 1/4″ clearance 😳. I wish I could take credit for having perfect planning and measurements but, this was all pure luck! I totally forgot to account for the bracket 🤦🏻‍♀️ but luckily it all worked out. How crazy is that?!?

So far, this space is turning out to be pretty awesome for us and I may actually end up using it! 😅 Thanks for joining me here and following along on this renovation. Please be sure to check out the other One Room Challenge guest participants and featured designers. If you have any questions, please don’t hesitate to reach out here!

Leave a Reply